Patches
Layers of Roof Cement at Laps
Thick cement at side laps can crack and trap water underneath. We remove what has let go and leave only firm, tested material under the new coat.
Elwood Metal Roof Coating Contractor
Restore Patched Metal Roofs With Coating That Grips Old Repairs
As an Elwood metal roof coating contractor, we coat shops, warehouses, and farm buildings in Elwood, testing every old patch so the new coating holds.
- Old patches tested first
- Loose repairs scraped back
- Grip checked before full coat
Elwood Roofs
Elwood Metal Roof Coating Over Old Patch Layers
Elwood metal roof coating jobs often start with a roof that has been patched several times. Those repairs decide the prep.
Mastic, roof cement, aluminum tape, and earlier coatings all show up on Elwood shops and farm buildings, sometimes stacked three deep at the same lap. A new coating holds only as well as the layer under it.
We set small test patches on each type of old repair, let them cure, and pull them by hand. What holds stays and gets primed; what lifts gets scraped back to bare steel.
- Test patch on each kind of old repair
- Loose mastic and tape scraped to bare steel
- Primer matched to what stays on the roof
- Results noted on your roof sketch
Roof Conditions
Metal Roof Coating Prep on Older Elwood Buildings
Older roofs around Elwood carry these four conditions more than most. Each one changes the prep before coating.
Fasteners
Screws Driven Through Old Tape
Tape laid over screw rows hides loose fasteners. Pulling the tape back shows which screws need replacing before the row is sealed again.
Rust
Rust Spreading Under Old Coatings
Peeling coatings let water sit against the steel, and rust creeps under the edge. Those areas are scraped to a firm boundary and primed.
Farm Buildings
Machine Sheds and Pole Barns
Farm buildings around Elwood often have exposed screws and laps with years of patching. Condensation from inside is checked so it gets its own fix apart from the roof.
Benefits
Benefits of Coating Your Roof
A coating applied over tested, firm repairs pays off on older Elwood roofs in these ways.
Elwood RoofsTested repairs, primed steel, then coating
Fewer Coating Failures
Testing old patches before coating finds the weak layers that would otherwise peel and take new coating with them.
One Uniform Surface
The patchwork of cement, tape, and mismatched paint disappears under one continuous coat that is easier to inspect.
Simpler Upkeep
With old repairs cleaned up, later maintenance means washing and recoating one known product.
Buildings Stay in Use
Shops and storage buildings keep working below while each section is prepped and coated.
Five Systems
Commercial Roof Coating Options for Elwood
Five systems are available in Elwood. Which one fits depends on how each section drains and what the old repairs leave behind.
Commercial Metal Roof Coating
The standard choice for patched steel once the old repairs are tested and every screw is sealed.
Commercial Metal Roof Coating details
Silicone Roof Coating
Used on low bays where years of patches have left dips that hold rainwater after storms.
Silicone Roof Coating details
Acrylic Roof Coating
A lower-cost topcoat for pitched Elwood shop roofs that drain well once the prep is done.
Acrylic Roof Coating details
Spray Foam Roofing
Covers heavily patched farm roofs in one layer and adds insulation under a protective coat.
Spray Foam Roofing details
Shingle Roof Coating
For shingle roofs on Elwood offices and halls that still lie flat and pass the bend test.
Shingle Roof Coating detailsOld Patch Leaking Again?
Leaking Now
Patches that keep failing in the same spot can mean water is getting in somewhere else. Call and tell us where it shows.
Call UsPlanning A Coating
Ready to coat over years of repairs? Get a free ballpark range for your Elwood roof size.
Get A Free EstimateThe Process
Metal Roof Coating Steps on Elwood Buildings
Elwood jobs follow five stages, with extra time on stage two for old repairs.
Inspect Your Roof
Every old patch, tape strip, and coated area is marked on a sketch. We note which ones look loose and which are firmly attached, then check for stains inside.
Patch MapTest Patches on Old Repairs
Small patches of the planned coating go over each type of old repair. Once cured, they are pulled by hand to see what holds.
Adhesion TestScrape, Wash, and Prime
Repairs that failed the test are scraped to bare steel, the roof is washed, and primer goes on bare and rusted areas.
PrepSeal Details and Coat the Field
Screws and laps are sealed, fabric is set at the worst laps, and the coating goes on to thickness across the whole roof.
CoatingFinal Walk With the Test Results
You get photos, the adhesion results, and thickness readings, so later repairs start from a known record.
RecordsNearby
Nearby Towns We Work In
Anderson
Plants, warehouses, and church halls in Anderson itself.
Anderson metal roof coatingPendleton
Several metal buildings on one lot, coated in turn.
Pendleton metal roof coatingHartford City
Industrial roofs with vents, stacks, and rust-through.
Hartford City metal roof coatingAlexandria
Leak history and past repairs guide the inspection.
Alexandria metal roof coatingFortville
Gutters and eaves decide silicone or acrylic.
Fortville metal roof coatingFAQ
Elwood Questions About Metal Roof Coating
What Does Elwood Metal Roof Coating Cost?
Our published range runs about $2.50 to $4.00 per square foot for coating and about $5 to $8 for replacement. Elwood roofs with many old patches sit higher in that range, since scraping and testing take time. The inspection sets the real number for your building.
Metal Roof Coating for Elwood Businesses: Do You Work Around Open Hours?
Yes. Work stays on the roof, so shops and offices keep their hours. We agree on staging spots, ladder locations, and which door crews use before the first day.
Is There Elwood Metal Roof Coating Near Me for a Farm Shop?
Farm shops and pole barns around Elwood are part of our regular area. The coating plan matches what a town building gets, with extra attention to exposed screws and to condensation from equipment or livestock inside.
Do You Coat Metal Roofs on Commercial and Farm Buildings in Elwood?
We do, on commercial buildings, shops, and farm structures across Elwood. Each job follows the same order as in Anderson: inspection, washing, rust treatment, sealing screws and laps, then coating. Exposed-fastener panels, common around Elwood, take coating well while the steel and framing stay firm.
Can You Coat Over Old Roof Cement?
Only where it is still firmly attached and passes a test patch. Cracked or lifting cement is scraped off, because a coating laid over it peels when the cement lets go.
Do Old Patches Have to Come Off Before Coating?
Just the ones that fail a test patch. Firm repairs stay in place and get primed, while loose cement, tape, and peeling coatings are scraped back to clean steel so the new coat has something solid to grip.
Free Estimate
Hire an Elwood Metal Roof Coating Contractor
Send the roof size for a ballpark range, or call to set up an inspection at your Elwood building.